Generating An Lf Sweep - Agilent Technologies Keysight N9310A User Manual

Using Functions
Generating a Step Swept Signal

Generating an LF Sweep

N O T E
38
To generate an LF sweep with the following settings:
• frequency range, 10 to 60 kHz, at a level of 500 mV
• six sweep points and 50 ms dwell time at each point
Pressing sets the sweep/point trigger to Immediate (IMM) and the
Preset
LF output amplitude to 500 mV. The following procedures do not include
the steps to set the sweep/point trigger and the LF output amplitude.
Refer to the following procedures to configure and generate
an LF sweep:
1
Preset
Press hardkey
2
Press Sweep hardkey
Press Step Sweep softkey
3
Press LF Start > 10 > kHz
4
Press LF Stop > 60 > kHz
5
Press # Points > 6 > Enter
6
Press Step Dwell > 50 > ms
7
Press Return > Sweep State > LF
8
This initiates the LF sweep output immediately via the LF
OUT connector. A SWEEP annunciator displays for the
duration of the sweep.
For more information about the sweep settings, please refer
"Sweep" on page 74
to .