Tuning Your Vcr And Satellite Receiver - Panasonic TX-15LT2 Operating Instructions Manual

Tuning your VCR and satellite receiver

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although a
Scart connection is preferable if the VCR is so equipped (see page 6 or 32 for suitable inputs to the Scart socket
on this TV.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or
sound from your VCR on programme position '0' of the TV. Either adjust the tuning of the TV's programme
position '0' (follow the instructions below) or adjust the RF channel of your VCR (some VCRs allow adjustment of
their RF channel via their remote control unit) or both until the TV receives the RF output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Tuning your TV to the VCR.
Switch on the VCR, insert and play a pre-recorded tape with known content
PICTURE
SOUND
SET UP
TV/AV
VCR
CH44
Manual tuning
21 68
VCR
The tape with known content
is found and displayed.
STR
Pressing will store the
setting.
SET UP
1
Press .
2
Move to chosen Tuning menu option by using
3
Access Tuning menu by using
4
Move to chosen Manual tuning by using
5
Access Manual tuning by using
6
Select programme position '0' VCR by using
7
Start searching for the VCR playback of the known content tape by using
When the VCR playback is found, press
TV/AV
Pressing to exit.
Notes:
• If picture patterning occurs on programme position '0' it may be
necessary to adjust the RF output channel of the VCR, refer to the
VCR instruction book.
• If a Satellite Receiver and a VCR are going to be used with RF cable
connections it is important to avoid both units being set on the same
channel.
Refer to the Satellite Receiver and VCR instruction books for precise
tuning information.
or
or .
or .
or .
or .
STR
to store.
.
or .
27