Montgomery Ward TPC2610C Owner's Manual page 14

c. Release bevel locking clamp andlift
housing until bladeis
Apply pressure to thelower
with thumb until thereisabout
betweenthesquareandthelower
blade. (Thiscompensatesfor
when tightening
adjusting screws.
d. Replacelower handlecover.
e. Tightenbevel lockingclamp.
CHECKINGTHE SAWBLADE
" eel- in the bladeistheconditionwhere,
blade moves ina paththat
bladeitself isnot squareto
thebladewiII not follow in the
andthus causesabindor
proceedasfollows:
1. Placeacarpenter's squareagainst the fenceand the
bladeas shown. Do not allow the squareto
thebladeteeth. Fig. 36.
2. If the blade is not square, remove theleft
carriage cover. NOTE: During
thesaw the carriage
thesaw.
3. Releasethe yokelock.
4. Locktheyokeindex.
5. Loosen adjusting screws
lockingscrews at sideof carriage.
6. Rotatethemotor untiIblade
7. Lock yoke locklever.
8. Tighten bothscrews
screws on top of carriage. After adjustment, yoke
indexlever shouldmovefreely
motor
parallel to thesquare.
part of saw blade
1/32- clearance
edgeof the
motor movement
screws.) Tighten the three
FOR "HEEL
althoughthe
is square to thefence,
thefence. The backteethof
saw kerf of thefront teeth
dragwhencutting. To check,
rest
side
initial assembly
covers arenot assembledto
(HandleDown)
at topof carriage,
Fig. 35.
is para lIel to thesquare.
at sideof carriage thenboth
but not drop.
ft
the
on
of
and