Removing And Replacing Handset In Cradle; Place Outside Call; Answering Incoming Call; End Call - Deklin Technologies DT100 Installation And Operation Manual

Removing and Replacing Handset in Cradle

To remove handset from the Cradle push the handset up into the
top of the cradle then pull bottom of handset out from cradle.
When replacing the handset push the top of the handset into the
top of the cradle, then set bottom of handset into cradle and let
the handset drop into place.

Place Outside Call

Lift handset and listen for a dial tone (The handset should
automatically come Off Hook). If the handset is already
removed from the cradle but is not currently connected to an
outside call then press the HOOK button and listen for a dial
tone. Dial telephone number. (Refer to the Operations
Instructions of your telephone system or Network Provider for information on phone number formats.)

Answering Incoming Call

Lift handset (The handset should come Off Hook). Start conversation. If the handset is already removed
from the cradle but is not currently connected to an outside call (Off Hook), then press the HOOK button
to connect to the incoming call.

End Call

Replace handset on base, or, press HOOK button.

7
Deklin Technologies, Inc. 2008