Removing And Replacing Handset On Locking Base; Place Outside Call; Answering Incoming Call; End Call - Deklin Technologies DT100 Installation And Operation Manual

Removing and Replacing Handset on Locking Base

To remove handset from the Locking Base pull firmly from the bottom of the
handset. When replacing the handset set the top of the handset on the base and
push the bottom firmly into place.

Place Outside Call

Lift handset and listen for a dial tone (The handset should automatically come Off
Hook). If the handset is already removed from the locking base but is not currently
connected to an outside call then press the HOOK button and listen for a dial tone.
Dial telephone number. (Refer to the Operations Instructions of your telephone
system or Network Provider for information on phone number format

Answering Incoming Call

Lift handset. (The handset should come Off Hook. Start conversation.) If the handset is already removed
from the locking base but is not currently connected to an outside call (Off Hook), then press the HOOK
button to connect to the incoming call.

End Call

Replace handset on base, or, press HOOK button. .

6
Deklin Technologies, Inc. 2008