Have a question regarding this manual? The material in this manual is for information purposes only and is subject to change without notice. Altman Lighting assumes no responsibility for any errors or omissions which may appear in this manual. Should you find an error, have a suggestion or question regarding your Altman Lighting product, we would love to hear from you.
Gallery Series LED Luminaires Installation & User’s Manual IMPORTANT INFORMATION Product Safety Notices When using electrical equipment, basic safety precautions should always be followed including the following: a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. b. Do not use outdoors unless the product is specified to operate in outdoor environments.
Altman Lighting, Inc., a subsidiary of Altman Stage Lighting Company, Inc., herein referred to as Altman, warrants each new product (except for spare parts or products Altman does not manufacture) for a period of TWO (2) years from date of shipment to correct by repair or replacement any part defect due to faulty material or workmanship.
Preface About this Manual ..........................5 Product Descriptions ..........................5 Accessories............................5 Gallery Series LED Luminaires Lens Tubes & Gate............... 5 Gallery Series LED Luminaires Other Accessories ................ 5 Gallery Series LED Luminaires Overview Gallery Series LED Luminaires Components..................6 Short and Long Zoom Luminaires ....................
Page 6
Installation & User’s Manual Troubleshooting Troubleshooting Guide ........................22 Technical Specifications Gallery Series LED Luminaires Common Specifications..............23 Gallery Series LED Luminaires Dimensions..................24 15 to 35 Degree Long Zoom Models.................... 24 25 to 50 Degree Short Zoom Models ................... 24 Beam Wash Models ........................
Please read all instructions before installing or using this product. Retain this manual for future reference. Product Descriptions This manual covers the all Gallery Series LED Luminaires models. Because these fixtures are configured at the time of ordering, please refer to the current product specification sheet for the model numbers and descriptions.
GALLERY SERIES LED LUMINAIRES OVERVIEW Gallery Series LED Luminaires Components Short and Long Zoom Luminaires Figure 1 shows the basic features of Short and Long Zoom Gallery Series LED Luminaires. Top Box (track models) Top Box (portable models) Refer to "Top Box Overview"...
Gallery Series LED Luminaires Installation & User’s Manual Flood Luminaires Figure 3 shows the basic features of Flood Gallery Series LED Luminaires. Top Box (track models) Top Box (portable models) Refer to "Top Box Overview" on page 8 for more information.
• Ceiling / Pendant The model(s) purchased determines how the unit can be mounted. Figure 4 shows the features and connections on the two versions of the Gallery Series Luminaire top boxes. Portable Models C-Clamp / Unistrut C-Clamp / Unistrut Mounting Point (mounting hole 1/2-in.
Installation & User’s Manual Power Requirements WARNING! The Gallery Series LED Luminaires should be connected to a constant circuit or a relay device. It should never be connected to a dimmer or circuit controlled by a dimmer unless the unit is specifically designed to do so (MAINS dimming models - 120VAC only).
Gallery Series Luminaire is tested with any alternate dimmer prior to utilization. Please note that the majority of phase-cut dimmers tested have resulted in proper dimming performance. For additional information, please contact customer service.
Step 4. The luminaire is now ready to connect to an AC source. 0-10V Controlled Models (Sink Current) Gallery Series LED Luminaires’ 0-10V drivers only operate with dimmers that sink current. They are not designed to operate with 0-10V controls systems that source current, as used in theatrical and entertainment systems.
Figure 9: 0-10V and Power Wiring Canopy / Pendant Mount Models Note: Ceiling junction box and junction box screws are not included with Gallery Series LED Luminaires and are by others. WARNING! Canopy / pendant mount models must be installed by qualified professional installer and should be done in accordance with local and national codes.
IMPORTANT! At the end of each DMX Daisy chain, it is highly recommended that a DMX TERMINATOR (Altman Lighting part number DMX-MPHX-TERM for the connectors shown in Table 4) is utilized on the last luminaire (or device) in the chain.
Note: * Only those pins shown are used. Remaining pins on RJ45 and XLR connectors are not used. Setting a DMX Address via RDM Gallery Series LED Luminaires are full featured Remote Device Management (RDM) compliant. All DMX and Luminaire settings are programmed via a RDM ANSI E1.20 complaint device. As many of the RDM...
Page 17
"Gallery Series LED Luminaires Other Accessories" on page 5 for ordering information) is used to set the DMX address of Gallery Series LED Luminaires (DMX Versions) using DMX/RDM. RDM (Remote Device Management) is an enhancement to DMX512 which allows status information and parameters (such as the DMX address) to be communicated over the DMX LAN.
Zoom Spot Models Zoom Spot Models Gallery Series LED Luminaires fitted with a short or long zoom lens, has the following features: • User-settable and lockable zoom and focus control • 4-blade shutter system (set on two planes) • Gobo slot for E-size gobos measuring 37.5 mm OD with a 28 mm image area. Gobo holder is included with all zoom spot models and can be purchased as an additional accessory.
Page 19
Zoom Spot Models Gallery Series LED Luminaires with zoom spot lenses have a gate assembly that contains four-blade shutters that can be moved by hand in and out of the beam for shutter cuts. The can moved as needed either straight out (or in) or at an angle. Figure 13 shows the gate and the four shutter blade handles.
Beam Wash Models Gallery Series LED Luminaires that have the beam wash lens are designed and are ideal to project a soft edge, even beam of light. For beam wash models, beam shaping is achieved through external, four-flap barn doors (sold separately).
Models All Gallery Series LED Luminaires can have their pan and tilt set by hand (without the use of tools). To adjust pan or tilt, loosen (do not remove) thumb screw or knob as indicated in Figure 16 and adjust pan or tilt as desired.
Gallery Series LED Luminaires. These types of cleaners or solvents can permanently damage the optics or housings of the fixture. If you have any questions regarding the use or care of your Gallery Series LED Luminaires, please contact Altman Lighting technical support or your local Authorized Dealer.
Step 6. Once lens is completely dry, reinstall lens assembly. Service and Maintenance For all other service and maintenance issues, please contact your local Altman Lighting office or an Authorized Service Center. WARNING! Disassembly (other than as described herein), alterations, unauthorized service, etc. will void the product warranty.
Troubleshooting Guide The chart below provides possible causes and remedies for various error messages and/or symptoms. If this chart is unable to address your issue, please contact your authorized dealer or Altman customer service at 1.914.476.7987 or customerservice@altmanlighting.com for assistance.
Listed to UL1573 & 1574, CE Marked Note: Common model specifications shown. For specific model specifications, features, and accessories, refer to the product specification sheet or visit the Altman Lighting web site at www.altmanlighting.com. Gallery Series LED Luminaires Common Specifications...
Gallery Series LED Luminairess Installation & User’s Manual Gallery Series LED Luminaires Dimensions 15 to 35 Degree Long Zoom Models 4.0 In. / 101.6 mm 7.9 In. / 200.7 mm Weight: 5.85 Lbs. / 2.65 Kg. 15.3 In. / 388.6 mm 6.7 In.
4.0 In. / 101.6 mm 7.9 In. / 200.7 mm Weight: 3.77 Lbs. / 1.71 Kg. 5.7 In. / 144.8 mm 6.7 In. / 170.2 mm Note: Track model shown. Common dimensions shown for flood models. Gallery Series LED Luminaires Dimensions...
Need help?
Do you have a question about the GALLERY SERIES and is the answer not in the manual?
Questions and answers