Auto Channel Setup (Ant/Cable Setup) - Panasonic TC-P42S2 Quick Setup Guide (English, Spanish) Operating Instructions Manual

Press to return to
the previous screen

Auto channel setup (ANT/Cable setup)

Select the connected Antenna in terminal
ANT/Cable setup
Step 3 of 6
Cable Antenna Not used
ANTENNA
Cable In
ANTENNA
Cable In
OK
Select "Not used" when viewing TV via
Select Satellite receiver or Cable box. Note: Select
RETURN
"Cable" when viewing via Cable DTA Box.
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
Typical when a Cable/Satellite box is connected to a TV input.
Prevents accidental tuning to an unavailable signal.
Select "Start"
Auto program Step 4 of 6
Start Skip
OK
Start scanning for channels via the TV's
built-in tuner. Select "Skip" when viewing TV
Select
RETURN channels via Satellite receiver or Cable box.
Start scanning the channels
(Available channels are automatically set.)
Auto program
Progress
8%
Number of analog channels
10
Number of digital channels
0
Press RETURN to quit
RETURN
Complete the Auto program setup
Completion message is displayed when the Auto program scan is successfully
completed.
Auto program
Number of analog channels
10
Number of digital channels
0
Auto program completed.
Press OK to continue.
OK
RETURN
Operation of the EXIT button during "First time setup"
Press the button once to display confirmation screen. Press again to close
confirmation screen.
[EXIT confirmation screen]
Are you sure you want to exit the First Time Setup?
Yes No
To repeat the First Time Setup, select
"First time setup" in the Setup Menu.
Not used: Go to
select
OK
Skip: Go to
select
OK
If there is no available
OK
channel, return to
(ANT/ Cable setup).
"Not used" will be selected.
Yes Exit "First time setup"
No Return to the original screen.
(Label inputs)
(Label inputs)
-
15