Table of Contents
Advertisement
(3) Nail Feeders (A) [71], (B) [75] and the related parts
[Tool required]
Roll pin puller (3 mm (0.118"), 4 mm (0.157") dia.)
(a) Disassembly
Fix Nail Feeder (B) [75] using a V-block and pull out the Roll Pin D4 x 40 [72] from the top using a roll pin
puller (4 mm (0.157") dia.). Then Nail Feeder (A) [71], Nail Feeder (B) [75] and Spring [73] can be
removed.
Pull out the Roll Pin D3 x 10 [76] with the roll pin puller (3 mm (0.118")). Then the Pushing Lever Stopper
[74] can be removed from Nail Feeder (B) [75].
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Insert the Pushing Lever Stopper [74] in Nail Feeder (B) [75] and secure with the Roll Pin D3 x 10 [76].
Insert the Roll Pin D4 x 40 [72] into Nail Feeder (B) [75]. Insert the Spring [73] into the hole of Nail Feeder
(B) [75] and compress the Spring [73] until it is engaged with the protrusion of Nail Feeder (A) [71].
--- 29 ---
Advertisement
Table of Contents
