Onkyo TX-RZ810 Basic Manual page 58

> Specifications > Settings
AccuEQ Room Calibration
To enable equalizer for each speakers, select "On".
Please select "All Channels", if you have same speakers for all
channels. Please select "Except Front Left / Right", if front
speakers are larger than other speakers.
On (All Channels)
On (Except Front Left / Right)
Off
If this is to be enabled, then normally you should
select "On (All Channels)", and to disable just the front
speakers you should select "On (Except Front Left /
Right)".
7. Disconnect the speaker setup microphone.
■ 2� Source Connection
Check that each input source is connected correctly.
Follow the guidance, select the input you want to confirm,
start play of the selected player, and confirm that the
images appear on the TV and that sound is played.
■ 3� Network Connection
Set up Wi-Fi connection with an access point such as a
wireless LAN router. There are the following two methods
of connecting by Wi-Fi:
"Scan Networks": Search for an access point from this
unit. Find out the SSID of the access point beforehand.
"Use iOS Device (iOS7 or later)": Share the iOS device's
Wi-Fi settings with this unit.
If you select "Scan Networks", there are a further two
choices of connection method. Check the following.
"Enter Password": Enter the password (or key) of the
access point to connect.
"Push Button": If the access point has an automatic
connection button, you can connect without entering a
password.
• If the SSID of the access point is not displayed, then in
the screen listing the SSIDs, select "Other..." with the
> Listening Modes > Playback Function
cursor on the remote controller and press ENTER, then
follow the onscreen instructions.
Keyboard input
Wi-Fi Setup
SSID
a
Next
n
1
,
When finished, select the "OK" key.
To switch between upper and lower case, select "A/a" on
the screen and press ENTER. To select whether to mask
the password with "
MEMORY on the remote controller. Pressing CLEAR will
delete all the input characters.
• A confirmation screen asking you to agree to the privacy
policy is displayed during network setting. Select "Yes"
and press ENTER to indicate agreement.
■ 4� Multi Zone Setup
Make these settings to enjoy video and audio in a room
other than the main room (ZONE 2/ZONE 3).
Select "Using AV Receiver" when connecting speakers
in the separate room. Select "with External Premain
Amplifier" when connecting a pre-main amplifier in the
separate room. Select "with External Power Amplifier"
when connecting a power amplifier.
If you are going to be connecting a TV in the separate
room (ZONE 2), then when "Would you be using TV in 2nd
room?" is displayed, select "Yes".
■ 5� Audio Return Channel
If you have connected a TV that supports ARC, select
"Yes". This unit's ARC setting turns on and you can listen
to the TV's audio through this unit.
• If you select "Yes", the HDMI CEC function is enabled
b c d e f g h i j k l m
o p q r s t u v w x y z
2 3 4 5 6 7 8 9 0 - ^ \
. / ; : @ [ ]
A/a OK
All Erase A/a
" or display it in plain text, press
＊
> Basic Manual
Troubleshooting | Appendix
and power consumption increases during standby.
25