Page 1
MEQ15BT INSTALLATION / OWNER'S MANUAL Wireless Smart EQ Processor FCC ID : GJW-SBT504 IC ID : 4038A-SBT504...
Page 2
INSTALLATION / OWNER'S MANUAL Preparation Please read the entire manual before installation. It is highly recommended that your Smart EQ be installed by a professional installer or an authorized dealer due to the highly technical nature of this product. Before Installing •...
INSTALLATION / OWNER'S MANUAL Connection Descriptions Power Wire (+12V) • Disconnect the negative battery terminal before processing. Consult a qualified technician if necessary. • Plan out the wire routing before cutting any wires to length. Begin by routing the power wire from the battery to Smart EQ. The power wire can be pigtailed from the amplifier.
Page 4
INSTALLATION / OWNER'S MANUAL Inputs/Output Panel Description INPUT Low Level Input (RCA) Power LED High Level Input Power Connector Reset OUTPUT REM Out for Amplifier Line Output Rear Line Output Subwoofer Line Output Front...
Page 5
INSTALLATION / OWNER'S MANUAL Typical Wire Routing 18” (1.5 feet) (Maximum) FUSE 12V BATTERY +12V DC (Power) [Subwoofer] [Head Unit] [Mono Amplifier] [Speakers] RCA (Low Level Input) [Smart EQ] [4-Channel Amplifier] REM Out (Remote Turn On/Off) (ACC) BLACK (GND) Yellow (B+) No more than 36"...
INSTALLATION / OWNER'S MANUAL Input Connections The input source for Smart EQ can be the head unit, via RCA or high level inputs, or a paired and connected Bluetooth media device. Note: The default setting for the input source is the head unit. To change the source, use the Smart EQ app on your mobile device (see 'Using Application' section on page 8).
INSTALLATION / OWNER'S MANUAL Output Connections Amplifier Connection • Remote Turn-on/off The remote output (REM OUT) of Smart EQ has to connect to the remote input (REM IN) terminal of an amplifier as below. When connected, this signal controls the power to the amplifier and turns it on if an audio signal is detected by Smart EQ.
INSTALLATION / OWNER'S MANUAL Using Application • Smart EQ App All of Smart EQ's settings and configurations can be accessed and controlled by Smart EQ app (available on iTunes App Store and Google Play Store) on a Bluetooth enabled iOS/Android device. When the unit is paired and connected, it will show the name of the Smart EQ.
Page 9
INSTALLATION / OWNER'S MANUAL Using Application Bluetooth Pairing Connect Smart EQ to Bluetooth enabled iOS/Android device in order to control Smart EQ. • Pairing the Smart EQ with Your Device Pairing is the process of connecting two devices over Bluetooth and allowing them to communicate.
INSTALLATION / OWNER'S MANUAL Troubleshooting Problem Cause Action +12V wire not connected or incorrect Check connections for proper voltage. voltage (11~16V DC) Unit will not turn on (Power LED is off) GND wire not connected Check connection to ground ACC wire not connected. Check connection to ACC line.
INSTALLATION / OWNER'S MANUAL Specifications Dimensions (HxWxD) • 1.2" (31mm) x 7" (177mm) x 4.1" (103.4mm) Power • 14.4V DC (10V-16V) Bluetooth • A2DP, AVRCP and SPP support • Bluetooth 2.1+ EDR • iOS and Android support • Range : up to 30 feet (10 meters) Audio input •...
Page 12
INSTALLATION / OWNER'S MANUAL Compliance ICC Compliance This Class [B] digital apparatus complies with Canadian ICES-003. FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause un-desired operation.