Problem & Solution; Customer Service - One for All URC-7940 Instruction Manual

Problem:
Your brand is not listed
in the code section?
The ONE FOR ALL does
not operate your
device(s)?
The ONE FOR ALL is not
performing commands
properly?
Problems changing
channels?
Video not recording?
The ONE FOR ALL does
not respond after
pressing a key?
The red LED does not
blink when you press
a key?
In the UK
E-mail : ofahelp@uebv.com (***)
Fax : +31 53 432 9816
Tel. : 0901-5510010 (£ 0,50 per minute)
In Ireland
E-mail : ofahelp@uebv.com (***)
Fax : +31 53 432 9816
Tel. : 016015986
In South Africa
E-mail : support@oneforall.co.za
Fax : 011 298 2302
Tel. : 0860 100551
Tel. : 011 298 2300
(***) Just send a blank message, you'll get auto-reply.
8
Problem & Solution

Customer Service

Solution:
Try the search method on page 6.
A) Try all the codes listed for
your brand. B) Try the search
method on page 6.
You may be using the wrong
code. Try repeating the Direct
Set-Up using another code listed
under your brand or start the
search method over again to
locate the proper code.
Enter the programme number
exactly as you would on your
original remote.
As a safety feature on your ONE
FOR ALL, you must press the
Record key twice.
Make sure you are using new
batteries and are aiming the one
for all at your device.
Replace batteries with 2 fresh,
new "AA" alkaline batteries.
In Australia
E-mail : ofahelp@uebv.com (***)
Fax : 03 9672 2479
Tel. : 1 300 888 298
In New Zealand
E-mail : ofahelp@uebv.com (***)
Fax : (06) 878 2760
Tel. : 0508 ONE 4 ALL (663 4 255)
WWW.ONEFORALL.COM