Panasonic KX-FC241AL Operating Instructions Manual page 96

Compact plain paper fax with dect
Table of Contents

Advertisement

12. Help
Problem
The ink film runs out
quickly.
The base unit beeps.
The speakerphone is not
working.
I cannot page a cordless
handset or base unit.
Caller information is not
displayed.
While viewing caller
information, the display
returns to standby mode.
12.3.3 Cordless handset
Problem
The cordless handset
does not work.
The cordless handset
display is blank.
The cordless handset will
not turn ON.
w is flashing.
The batteries should be
charging but the battery
icon does not change.
A busy tone is heard when
{C} is pressed.
94
Cause & Solution
L The help printing function, copy function, and reports also use ink
film.
L Even if there are only a few sentences, every page that comes out
of the machine is considered a full page.
L Turn OFF the following features:
– sending report: feature #04 on page 66.
– journal report: feature #22 on page 67.
– Caller ID list: feature #26 on page 68.
L Recording paper/ink film has run out. Press {STOP} to stop the
beeps and install paper/ink film.
L Use the speakerphone in a quiet room.
L If you have difficulty hearing the other party, adjust the volume.
L The called cordless handset is too far from the base unit.
L The called unit is in use. Try again later.
L You have not subscribed to Caller ID service.
L The caller requested not to send his/her information.
L Do not pause for over 1 minute on the cordless handset or 3
minutes on the base unit while searching.
Cause & Solution
L Make sure that the batteries are installed correctly (page 21).
L Charge the batteries fully (page 23).
L Clean the charge contacts and charge again (page 23).
L Turn the cordless handset power OFF, then ON (page 24).
L Check that the power cord is connected properly.
L The cordless handset has not been registered to the base unit.
Register the cordless handset (page 81).
L Re-install the batteries (page 21) and charge them fully.
L The cordless handset is not turned ON. Turn the power ON (page
24).
L Make sure that the batteries are installed correctly (page 21).
L Charge the batteries fully (page 23).
L Clean the charge contacts and charge again (page 23).
L The cordless handset is not registered to the base unit. Register it
(page 81).
L The cordless handset is too far from the base unit. Move closer.
L The power cord is not connected. Check the connections.
L Clean the charge contacts and charge again (page 23).
L The AC adaptor is disconnected. Plug in the AC adaptor.
L The cordless handset is too far from the base unit. Move closer and
try again.
L The base unit or another cordless handset is on an outside call.
Wait for the other user to complete the call.

Advertisement

Table of Contents
loading

Table of Contents