Advertisement
Advertisement
Installation Instructions Document No. 570-111 February 18, 2013 Operator Display Panel II (ODP II) Product Description These instructions explain how to field install or replace the BACnet Fume Hood Controller FHC. The Fume Hood Controller Operator Display Panel (ODP) is the interface between the fume hood operator and the controller system.
5. Push until locking tab clicks in place. ODP. 2. Attach the mounting plate to the mounting surface using the screws provided. NOTE: The height of the screw heads must not exceed 3 mm. Page 2 of 4 Siemens Industry, Inc.
6. Connect the power module to the ODP and Fume Hood Controller. The installation is complete. Dismounting the ODP 1. Push the locking tab with a screwdriver until it releases. Mounting plate dimensions. 2. Remove the display fro the mounting plate. Siemens Industry, Inc. Page 3 of 4...
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners. © 2013 Siemens Industry, Inc. Siemens Industry, Inc.
Comments to this Manuals
Latest comments: