Step 1 Connection; Q Link Functions - Panasonic Diga DMR-ES20 Operating Instructions Manual

1
STEP Connection
•
The equipment connections described are examples.
•
Before connection, turn off all equipment and read the appropriate operating instructions.
•
Peripheral equipment and optional cables are sold separately unless otherwise indicated.
Connecting a television with 21-pin Scart terminal and VCR
When there is no 21-pin Scart terminal on the television (➔ page 8)
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
To the aerial
Television's rear panel
Splitter
VHF/UHF
RF IN
Aerial
cable
This unit's
rear panel
21-pin Scart cable
Use a splitter if you also
want to connect the
aerial to your VCR.
VHF/UHF
RF IN
■ RGB
This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.

■ Q Link functions

Q Link offers a range of convenient functions (For further details ➔ page 41). Make sure to connect a fully wired 21-pin Scart cable to the
television if using the Q Link function.
The following systems from other manufacturers have similar function to Q Link from Panasonic. For details, refer to your television's operating
instructions or consult your dealer.
•
Q Link (registered trademark of Panasonic)
•
DATA LOGIC (registered trademark of Metz)
•
Easy Link (registered trademark of Philips)
■ Do not connect the unit through a video cassette recorder
Video signals fed through video cassette recorders will be affected by copyright
protection systems and the picture will not be shown correctly on the television.
•
When connecting to a television with a built in VCR, connect to the input terminals on
the television side, not the VCR side.
■ When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit
consumes a small amount of power, even when it is turned off
[approx. 3 W (Power Save mode)].
AV IN
RF coaxial
Fully wired 21-pin
cable
Scart cable
AV1 terminal
If your television is equipped with RGB input
capability, by connecting with a fully wired 21-pin
Scart cable you can see video using RGB output on
this unit (➔ below).
To output in RGB select "RGB ( without component )"
from "AV1 Output" in the SETUP menu (➔ page 35)
AV OUT
after tuning is completed (➔ page 10, 11).
VCR's rear panel
AC mains lead
Connect only after all other
connections are complete.
•
Megalogic (registered trademark of Grundig)
•
SMARTLINK (registered trademark of Sony)
Television
This unit
VCR
Before moving the unit, ensure the disc tray is
empty.
Failure to do so will risk severely damaging the disc and
the unit.
To household mains socket
(AC 220 to 240 V, 50 Hz)
Television
VCR
This unit
RQT8212
7