Philips 32PFL3605/77 Service Manual page 13

See Figure 4-5 and Figure
1. Unplug the speaker connector [1] from the SSB and
remove the wire wrap from this cable.
2. Remove the fixation screws from the speakers [2].
3. Take the speakers out.
When defective, replace the whole unit.
4.3.3 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU. See
1. Unplug all connectors [3] from the PSU.
2. Remove all fixation screws [4] from the PSU.
3. The PSU can now be taken out of the set.
When defective, replace the whole unit.
4.3.4 Small Signal Board (SSB)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB. See
1. Release the clips from both the LVDS Flat Foil
connectors [5].
Caution: be careful, as these are very fragile connectors!
Take the flat foils out of their connectors.
2. Unplug all other connectors [1] and [6].
3. Remove grounding screws [7] from the stand support.
4. Remove all other fixation screws [8] from the SSB.
5. The SSB can now be lifted upwards away from the bottom
shield cover.
Caution: be careful not to damage the bottom shielding
between the SSB and the plastic stand-off.
4.3.5 Stand support plate
1
1
Figure 4-7 Stand support plate (32")
4-6.
Figure 4-5 and Figure 4-6.
Figure 4-5 and Figure 4-6.
2
1
2 2
18930_105_100304.eps
Mechanical Instructions
1
1
Figure 4-8 Stand support plate (42")
See Figure 4-7
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove shielding fixation screws [1]. See
4. Remove stand support plate fixation screws [2].
5. Lift up the support plate together with the stand.
100304
RAM1.0L LA 4.
2
2
2
18930_124_100305.eps
and Figure 4-8.
EN 13
1
100305
Figure 4-7
2010-Jul-02