Page 2
Rhima Australia can be contacted 24 hours a day, 7 days a week. Call 1800 659 292. After normal business hours you will hear “Rhima Australia, general enquires or service call?” For technical matters refer to “service call”...
Page 3
Rhima Australia will repair or replace any parts, which in Rhima Australia's sole judgement are defective in material and/or workmanship. No responsibility will be accepted for repairs, defects or damages due to improper installation, misuse or neglect.
Page 4
No responsibility will be accepted for defects or damages by improper installation. In no event will Rhima Australia be liable for loss of facilities or other property and such things as - but not limited to - additional labour costs, loss of revenue or anticipated profits and other damages of any kind whether direct, indirect, incidental or consequential.
Page 5
Inspect and check your appliance. In case of evident damages, immediately inform your dealer and his carrier. In case of doubt, do not install the appliance until specialised tech- nicians have thoroughly checked its functions. Level the appliance by adjusting the screw feet. Level side to side as well as front to back. For added safety secure the appliance to a wall by means of a tie down strap.
Page 6
The GS-40 has a drain pump and is supplied with a grey outlet hose which must have a fixed watertight seal above the tundish in accordance with Australian Standard AS/NZS 3500.2. It is still recommended that the tundish be lower than the appliance outlet.
Page 7
Electrical connection All Rhima warewashing appliances are pre-wired and supplied complete with connecting cable and appropriate plug. This cable should be connected to a separate power supply by means of an isolator or appropriate plug and socket and in such a way that a safe and trouble-free use of the appliance is guaranteed.
Page 8
Rhima Australia Pty Ltd ABN 63 007 242 604 72-74 Woodlands Drive Braeside 3195 PO Box 605 Braeside Vic 3195 Tel: 1800 659 292 or 03 8586 5444 Fax: 03 8586 5454 www.rhima.com.au...
Need help?
Do you have a question about the GS-40 and is the answer not in the manual?
Questions and answers