Vhs Deck And Cassette Tape Information; The Remote Control - Panasonic NV-VP33 Series Operating Instructions Manual

VHS Deck and Cassette Tape Information

ª Surge Absorber
For further protection for this product, these models are equipped
with new surge absorbing circuits which prevents damage due to
power surges caused by lightning.
≥This function may not be effective for surges by direct lightning.
ª Crystal View Control
The crystal view control function ensures the optimum picture quality
so that you get the best picture automatically.
ª Tapes
≥You can use tapes with the VHS and S-VHS marks, but this unit is
unable to make full use of the characteristics of S-VHS tapes.
≥Break the tape's tab to prevent accidental
erasure. Cover the hole with a double layer
of adhesive tape when you want to use the
tape for recording again.
ª S-VHS Quasi Playback (SQPB)
It is possible to play back tapes recorded in the S-VHS system.
≥Some picture noise may occur depending on the type of tape used.
≥It is not possible to fully obtain the high resolution that S-VHS is
capable of.
It is not possible to record in the S-VHS system with this unit.

The Remote Control

ª Installing the batteries
Insert the batteries with the polarity (+ and -) correctly aligned.
Notes:
The service life of the batteries is approximately 1 year. However, it
varies considerably depending on the frequency of use.
≥When the batteries are exhausted, remove them immediately and
dispose them correctly.
≥Do not mix old battery with new battery.
≥Do not mix different battery types, i.e. Alkaline and Manganese.
≥Do not use rechargeable batteries.
≥Do not heat or short-circuit the batteries.
≥When you do not use the remote control for a long time, take out
the batteries and store them in a cool, dry place.
≥Operation can be affected by strong light sources, such as direct
sunlight, fluorescent light and the glass doors on cabinets.
4
RQTV0057
Tab
R6, AA, UM-3
ª Dirt on the video heads
If the video heads get dirty, pictures will not be recorded or played
back clearly. (See the following conditions.)
Normal picture Small amount of dirt
If this happens, insert and eject a cassette 5
to remove the dirt from the video heads.
If the problem still persists after performing above, contact a service
personnel.
Head cleaning by service agents is not covered by
warranty.
Heads mainly become dirty because of scratched or dirty tapes, use
of the unit under high temperature and humidity or under the dust
and other reasons.
Never use tapes on which liquids have been spilt or those that are
extremely damaged since these will cause not only the heads to
become dirty, but also the unit malfunction.
ª Use
Aim at the receiver window (l 6), avoiding obstacles, at a maximum
range of 7 m directly in front of the unit.
≥Keep the transmission window and the unit's sensor free from dust.
≥Operation can be affected by strong light sources, such as direct
sunlight, and the glass doors on cabinets.
Large amount of dirt
–
10 times successively