Weight Based Grinding Operation - Baratza SETTE 270W Manual

®

WEIGHT BASED GRINDING OPERATION

Place the portafilter, grounds bin or other brewing device on to
the convertible arms. Press a preset button (1,2,3). The screen
will show the corresponding programmed grind weight in grams.
Press START. There may be a slight delay as the machine Tares
and then begins grinding. While grinding, the screen will count
up in grams to the target weight, the motor will stop, hitting the
desired gram amount.
If you would like to stop before the cycle has completed, press
the STOP button. This will turn the motor off, and reset the
screen to your initially chosen grind weight. However, if you would like to pause the grind without resetting to the initially
chosen grind weight, press the PAUSE button. This will immediately pause the machine, and the screen will flash the
ground coffee weight. By pressing START it will continue grinding towards the desired weight. To reset the grind cycle
press the STOP button.
PULSE FUNCTION/MANUAL MODE
The Sette™ 270W also has a pulse function/manual weight grinding mode. To turn the grinder on in this mode, simply
hold the play button for more than 2 seconds, the Sette will TARE and the motor will turn on. The grinder will count up as it
measures the ground coffee, and will turn off as soon as you let go of the button. At this point the START button is now a
pulse button. To exit this mode, press STOP .
PROGRAMMING
The Sette is equipped with three programmable buttons. The buttons are simply labeled 1,2 and 3. These programmable
buttons only adjust the gram amount for coffee to be ground, they do not adjust the grind setting. Each button comes from
the factory with the following presets: Time: 1=18g, 2=25g, 3=35g
You can easily program more or less grams as follows:
1. Select a preset button.
2. Press the up or down arrow buttons to adjust the weight. If you press and hold the up or down arrow for two
seconds, the numbers will speed up.
3. Once you have reached the desired weight setting, press and hold the preset button for three seconds. The
setting will blink to confirm the setting is stored.
4. To program the other buttons repeat steps 1-4. If the grinder is unplugged it will retain the stored setting.
SETTE™ 270W MANUAL
7
v1 October 21, 2016