NetScreen Technologies 5GT User Manual page 10

Chapter 1 Connecting the Device
In addition to a NetScreen-5GT device, rack-mount kit, and equipment rack, you also
need the following:
• Phillips-head screwdriver
• Four screws that match the thread size of the equipment rack
To mount the device in a rack:
1. Use the Phillips-head screwdriver to remove the two screws from the underside
of each NetScreen-5GT device that you intend to mount. The screws are located
on the underside of the NetScreen-5GT near the front panel. (Keep the screws
for use in the next step.)
Remove the screws.
2. Insert the NetScreen-5GT devices on the rack-mount tray and screw them to the
tray with the screws that you removed in step 1.
Insert the devices
on the tray.
Screw the devices
to the tray.
3. Screw the left and right tray plates to the equipment rack.
Screw the tray
to the rack.
You can run power cords and ethernet cables through the openings in the floor of the tray
or out the depressions in the back wall. You can also use the space behind the devices to
hold power supplies. The switching power supplies, which you can order separately, fit
easily in a 1-RU height space.
6 User's Guide