Deteknix Quest Pro User Manual page 13

Pinpointing & Depth Reading
1. When the detector detects a buried
target, continue sweeping the search
coil over the target in a narrowing side-
to-side motion. You can press on
Pinpoint button for non-motion mode
to continuously responding.
2. Make a visual note of exact spot on the
ground where the detector beeps.
Stop the search coil directly over this
point on the ground. Then move the
search coil straight forward away from
you and straight back towards you a
couple of times.
Repeat steps 1~3 at a right angle to the
original search line, Make a
mark of "X" . The target will be
directly below the "X" at the
point of the beep response.
3. Once you press on the P button
the depth reading function will
be activated.
4. The depth is for reference only.
Digging
1. A Diamond Digger(1503.101,102) or Sparta Spade(1601.101) are
good tools for recovering targets. Using our sharp tools, cut a neat
portion of grass or soil and place it on a plastic sheet. This prevents
the material being scattered around and allows the hole to be refilled
quickly.
2. Check the hole for the target. Thanks to the light and balance weight,
you can grab the Quest from the cam-lock position to check the target
when you knee on the ground narrow the target's position.
3. We strongly recommend you to use a Xpointer to recovery the target.
It save your digging time and energy. You just need reach the
pinpointer's tip into the hole or dirt to lock the target. If the pinpointer
alarmed when you search in the hole, you may need to dig more dirt
out.
RECOVERING