Table of Contents
Advertisement
Inserting/Removing the Batteries
• Check that the camera is turned off and
that the lens is retracted.
• Use oxyride batteries (supplied), alkaline
batteries (optional) or Ni-MH batteries
(optional).
1 Slide the battery door to open it.
2 Insert the batteries observing the
direction of the + and -
polarities.
Preparation
3 1 Close the battery door.
2 Slide the battery door to the
end and then close it firmly.
• Select the type of battery in use on
[BATTERY TYPE] in the [SETUP] menu.
(P23)
• If you will not be using the camera for a
long time, remove the batteries.
• When new batteries or fully charged
Ni-MH batteries have been inserted for
more than 3 hours, the clock setting is
stored (in the camera) for at least
3 months even if the batteries are
removed. (The storing time may be
shorter if the batteries are not charged
sufficiently.)
If more than 3 months has passed, the
clock setting will be lost. In this case, set
the clock again. (P22)
• Do not remove the card and the
batteries during an access. The data
on the built-in memory or the card may
be damaged. (P20)
• Remove the batteries after the LCD
monitor and the status indicator
(green) are turned off. Otherwise, the
settings on the camera may not be
stored properly.
17
VQT0P83
Advertisement
Table of Contents
