Table of Contents
Advertisement
ª When using Windows 2000 Professional, Windows Me, Windows 98/98 SE
or Mac OS 9.x
• When connecting the camera to a PC, do not set [USB MODE] to [PTP].
(When the camera is shipped, [Mass Storage] is selected.)
• When using [Mass Storage] on Windows 98/98 SE, install the USB driver before
connecting. (When using Windows Me/2000/XP, Mac OS 9.x and Mac OS X, you
do not have to install the USB driver.)
• When connecting to the PC which includes the
above-mentioned OS with setting the [USB MODE] to [PTP],
the messages shown on the right appear on the LCD
monitor of the camera.
The following messages appear for each OS on the display of the PC. Select
[Cancel] to close the window and disconnect the PC.
OS
Windows 2000 Professional
Windows Me
Windows 98/98 SE
Mac OS 9.x
Playback (advanced)
[Welcome to the Found New Hardware
Wizard]
[New Hardware Found]>
[Add New Hardware Wizard]
(When you connect to the PC more than
2 times, only [Add New Hardware Wizard]
appears.)
[Software needed for the USB device
"DMC-FZ10" is not available. Would you like to
look for the software on the Internet?]
106
USB MODE
PTP
Message
Advertisement
Table of Contents
