Table of Contents
Advertisement
WARRANTY
OKINA USA Products are covered under warranty for one year from the date of purchase. The warranty will
automatically be voided if any of the following occurs:
1. Product sticker is removed
If the product sticker is removed, we will not be able to confirm any information regarding when and where the
product was purchased. We have no other way to verify the purchase record without the serial number on the
product sticker; therefore, it should not be removed.
2. Product is modified in any way
If the product is scratched, damaged, or modified in a manner not described in this manual, the warranty will be
voided immediately. It is the customer's responsibility to keep the product in good condition.
3. Power cable is cut
The power cable and any other cable should not be tampered with. Cutting or modifying of the cables will result in
termination of the warranty.
IMPORTANT NOTE
1. Read and follow instructions
All operating and user instructions should be read and followed before the unit is to be operated.
2. Secure all screws
Please make sure all rust-proof stainless steel screws are installed securely to ensure a waterproof seal.
3. Electrical connections
Only a qualified electrician should be allowed to make electrical connections.
4. Do not disassemble the product
Do not disassemble the product as it is dangerous and may cause damage to the product. Refer all servicing to
qualified service personnel.
5. Handle the product with care
Be careful when handling the product. Do not drop it or subject it to strong shock or vibrations in order to prevent
any damage to the product. Do not handle the product in a wet environment or when your hands are wet.
6. Reducing risk
To reduce risk of fire or electric shock, do not remove cover. Do not open product in wet weather. No user serviceable
parts inside. Refer servicing to qualified service personnel.
7. Unpacking
Unpack carefully. Electronic components can be damaged if improperly handled or dropped. If an item appears to
have been damaged during shipment, please place it properly in its carton and notify the shipper.
8. Installation notice
Tropical, coastal salt water environment:
If you plan to install this product into a tropical, sea, coastal salt water or corrosive industrial water/mist
environment, please seal each stainless screw and fitting with a silicon grease compound. This will help prevent
electrolysis corrosion occurring and extend the lifespan of the product and housing and prevent premature
deterioration.
9. Voltage
If you are using a camera which requires a 24V AC power input, please run a separate power line to the camera.
7
HI7-TKHBL_HI11-TKHBL_rev042709
Advertisement
Table of Contents
