Huawei Quidway S2700 series Configuration Manual page 13

Quidway S2700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 1-1 Networking diagram for configuring IPv4 static routes
Switch A
Switch
SwitchA
SwitchA
SwitchB
SwitchB
SwitchB
SwitchC
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Issue 01 (2011-07-15)
PC2
1.1.2.2/24
Eth0/0/1
Switch B
Eth0/0/1
Eth0/0/2
PC1
1.1.1.2/24
Interface
Eth0/0/1
Eth 0/0/2
Eth 0/0/1
Eth 0/0/2
Eth 0/0/3
Eth 0/0/1
Eth 0/0/2
Create a VLAN to which each interface belongs.
Assign an IP address to each VLANIF interface.
Configure a default IP gateway on each host.
Configure static routes and default routes on each switch.
The IDs of the VLANs to which the interfaces belong are shown in
The VLANIF interfaces and the IP addresses of the hosts are shown in
The next hop address of the default route on Switch A is 1.1.4.2.
The destination address of Switch B is 1.1.1.0, and the next hop address of the static route
is 1.1.4.1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth0/0/3
Eth0/0/2
Switch C
Eth0/0/1
Eth0/0/2
PC3
1.1.3.2/24
1 IP Static Route Configuration
VLANIF Interface IP Address
VLANIF 10 1.1.4.1/30
VLANIF 30 1.1.1.1/24
VLANIF 10 1.1.4.2/30
VLANIF 20 1.1.4.5/30
VLANIF 40 1.1.2.1/24
VLANIF 20 1.1.4.6/30
VLANIF 50 1.1.3.1/24
Figure
Figure
1-1.
1-1.
8