Advertisement
WE RECOMMEND THE FITTING OF A TRIPPLE ACTION FILTER.
ONLY TEFLON TAPE TO BE USED WHERE NECESSARY.
UNDER NO CIRCUMSTANCES IS PLUMBERS PASTE TO BE USED.
DO NOT CONNECT TO HOT WATER LINE— TO DO SO WILL VOID WARRANTY.
AFTER POWER IS ON — ALLOW 45 MINUTES BEFORE USING
DO NOT PLUG IN OR TURN ON POWER
1.
Fit tap on to the outlet connection provided.
2.
Mount unit on wall using fixing points on the back of the unit. It is advisable to position the tap outlet over a drain
board, so that in the event of a leaking tap the water can be disposed via the sink.
3.
Connect cold water supply to inlet (12mm) through a stop tap in the supply line. (stop tap to be provided by installer)
4.
Connect the overflow pipe to waste or any other area where water can be disposed of in a safe manner.
5.
Plug unit into 10 amp power outlet. *If installing larger 3.6kw element model, be sure that lead and plug is 15amp.
The same as power outlet.
6.
Turn "ON" water supply to unit and "OPEN" the outlet tap.
7.
Wait until water flows out of the tap.
8.
When water flows out of the tap please SWITCH THE POWER ON.
UNIT MUST BE POSITIVELY EARTHED
BEFORE USING:
Advertisement
