Disassembly Procedure For The Lens - Panasonic DMC-FS4P Service Manual

8.4. Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To minimize the possibility of the CCD being dirt, perform
disassemble and/or assemble under the condition of the
CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item
8.6.
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease (RFKZ0472) to the point where is
shown to "Grease apply" in the figure.
When the grease is applied, use a toothpick and apply
thinly.
6. When repair the drive frame, drive frame and direct
frame, must be unit exchange.
8.4.1. Removal of the Zoom Motor Unit
and Lens FPC P.C.B. Unit
1. Peal the 3 barrier sheets.
2. Remove the 1 solder (A).
3. Remove the 3 locks.
4. Unscrew the 2 screws (A).
5. Remove the zoom motor unit to the indicated by arrow.
6. Remove the 1 solder (B).
7. Unscrew the 1 screw (B).
8. Remove the lens flex to the indicated by arrow.
27