Colour Temperature; Picture Noise Reduction; Artificial Intelligence; Scan Mode - Panasonic TX-68P200A Operating Instructions Manual

Picture Menu Operation
C. TEMP
P-NR
AI

SCAN MODE

Note:
We recommend that you set the SCAN MODE to PROGRESSIVE when viewing a PAL 60 or NTSC
transmission. When viewing a PAL transmission (other than PAL 60) with the SCAN MODE set to
PROGRESSIVE, the screen will flicker. This is not a fault.
Normalisation
Pushing the Normal (
picture settings to the factory preset levels. This is called "Normalisation".
Normalisation will not occur if the Picture Menu is not displayed when the Normal (
The C. TEMP (Colour Temperature) control allows
you to change the White balance setting between
Standard, Warm and Cool.
Use the or buttons to switch between settings.
The P-NR (Picture Noise Reduction) system is
designed to reduce picture noise during poor
quality reception conditions. Pushing the left or
right buttons will change the setting between OFF,
STRONG, WEAK and AUTO.
Use the or buttons to switch between settings.
When the AI (Artificial Intelligence) is turned on it
continually and precisely detects fine differences in
the picture signal. It also detects the differences in
the brightness, black level and contrast levels.
Use the or buttons to switch the AI on or off.
The SCAN MODE control allows you to change
the Picture refresh setting between AUTO, 100Hz
MODE and PROGRESSIVE.
Use the or buttons to switch between settings.
AUTO The TV software will select the best mode for the signal being
viewed.
100Hz MODE 100Hz will give a steady picture for most signals.
PROGRESSIVE Recommended when receiving NTSC signals.
Switching is also possible using the
N
) Button on the remote control, when the Picture Menu is displayed will return all
PICTURE
MENU
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
P-NR
PICTURE
MENU
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
P-NR
PICTURE
AI
SCAN MODE
PICTURE
AI
SCAN MODE
button on the remote control.
) Button is Pushed.
DYNAMIC
STANDARD
AUTO
DYNAMIC
STANDARD
AUTO
ON
AUTO
ON
AUTO
13