Relearn Procedure; Electrical Power Outlets - Dodge Charger 2016 Owner's Manual

Relearn Procedure

For vehicles equipped with a sunroof, there is a relearn
procedure that allows you to calibrate the sunroof when
the "Auto Up" feature stops working. To reset the
sunroof, follow these steps:
1. Set the ignition to the ACC ON/RUN position.
2. Ensure that the sunroof is in the Fully Closed position.
3. Push and hold the Close switch. The sunroof will hit
the hard stop and move to the Vent position after 10
seconds.
4. Release the Close switch, then push and hold the
Close switch again within 5 seconds to begin the
teaching process. The sunroof will complete one full
cycle and return to the Fully Closed position.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 243
NOTE: If the Close switch is released anytime during the
teach cycle, the procedure will need to be repeated
starting from the first step.
5. Once the sunroof has stopped in the Fully Closed
position, release the Close switch. The sunroof is now
reset and ready to use.

ELECTRICAL POWER OUTLETS

Your vehicle is equipped with one 12 Volt (13 Amp)
power outlet on the instrument panel and one 12 Volt (10
Amp) power outlet in the center console that can be used
to power cellular phones, small electronics and other low
powered electrical accessories. The power outlets are
labeled with either a "key" or a "battery" symbol to
indicate how the outlet is powered. Power outlets labeled
with a "key" are powered when the ignition switch is in
the ON or ACC position, while the outlets labeled with a
"battery" are connected directly to the battery and pow-
ered at all times.
3