Panasonic DMR-E95H Operating Instructions Manual page 7

Connecting a television with 21-pin Scart terminal and Satellite receiver
≥When there is no 21-pin Scart terminal on the television (➡page 8)
≥Change the "AV2 Input" setting to match the output from a satellite receiver and set the "AV2 Connection" setting to "Normal" in the SETUP
menu (➡ page 50) after tuning is completed (➡page 11, 12).
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
1 4
To household mains socket
(AC 220–240 V, 50 Hz)
AC mains lead
Connect only after all other
connections are complete.
Cooling fan
AC IN
This unit's rear panel
∫ To view satellite programmes
Press [INPUT SELECT] to select the input channel "A2" for the satellite receiver or put this unit in standby mode.
∫ RGB
This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.
Television's
rear panel
VIDEO S-VIDEO
R - AUDIO - L
OPTICAL
DIGITAL AUDIO OUT R - AUDIO - L VIDEO
(PCM/BITSTREAM)
AV1 terminal
If your television is equipped with RGB input
capability, by connecting with a fully wired 21-pin
Scart lead you can see video using RGB output on
this unit (➡ below).
To output in RGB select "RGB (without component)"
from "AV1 Output" in the SETUP menu (➡ page 50)
after tuning is completed (➡ page 11, 12).
Satellite receiver's rear panel
BE SURE TO READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 2 BEFORE CONNECTION.
AV IN
Fully wired 21-pin
Scart lead
3
AV1 (TV)
AV2 (DECODER/EXT)
S-VIDEO
DVD/VCR
VHF/UHF
To the
RF IN
aerial
RF coaxial lead
1
Aerial
2
lead
Y
RF IN
P B
P R
COMPONENT
RF OUT
VIDEO OUT
(PROGRESSIVE/
INTERLACE)
Fully wired 21-pin
Scart lead
RQT7467
7