Tuning Your Vcr And Satellite Receiver; Tuning Your Tv To The Vcr - Panasonic TH-42PA20 Operating Instructions Manual

Tuning your VCR and satellite receiver

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although a Scart
connection is preferable if the VCR is so equipped (see page 9, 10 or 44 for suitable inputs to the Scart socket on this
set.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound
from your VCR on programme position '0' of this set. Either adjust the tuning of this TV programme position '0' (follow
the instructions below) or adjust the RF channel of your VCR (some VCR's allow adjustment of their RF channel via
their remote control unit) or both until this TV the RF output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.

Tuning your TV to the VCR

Switch on the VCR, insert and play a pre-recorded tape with known content.
1
2
1 2 3
4 5 6
7 8 9
0
C
3
N
4
Notes:
• If picture patterning occurs on programme position '0' it may be necessary to adjust the RF output channel of the
VCR, refer to the VCR instruction book.
• If a Satellite Receiver and a VCR are going to be used with RF cable connections it is important to avoid both units
being set on the same channel.
Refer to the Satellite Receiver and VCR instruction books for precise tuning information.
40
SET UP
Press to display the Setup menu
screen.
Press to select the Tuning menu.
Press to Access the Tuning menu
screen.
Press to select the Manual tuning.
Press to Access the Manual
tuning screen.
Press to select program position '0'
VCR.
Press to start seaching for the
VCR playback of the known
content tape.
When the VCR playback is found,
STR
press
TV/AV
Press to exit.
to store.
Setup menu
Q-Link
Off
AV2 out TV
Teletext
TOP
Off timer Off
Text language
West
Side panel
Off
Power save
Off
Access
Tuning menu
OSD language
Tuning menu
Programme edit
Auto setup
Manual tuning Access
Fine tuning
Colour system
Auto
Volume correc.
Decoder (AV2)
Off
VCR
CH44
Programme
down / up
Serch
Return
down / up
TV/AV E x i t
'STR' Button Store
Manual tuning
02 99:21 41
VCR
The tape with known content
is found and displayed.
STR
Pressing will store the
setting.