Panasonic KX-TWA51EX Installation Manual page 5

TWA51EX(ex).book Page 5 Thursday, February 12, 2009 11:42 AM
Battery installation/Battery charge
Important:
• Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit's operating
instructions.
• Wipe the battery ends ( ,
S T
• Avoid touching the battery ends (
• Confirm correct polarities (
S
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends ( ,
S T
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih} for
few seconds to turn the handset on.
1
Handset:
{j/OK}
2
{V}/{^}: "Settings" i {>}
3
{V}/{^}: "Registration" i {>}
4
{V}/{^}: "Register H.set" i {>}
5
Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
• The GSM network indicator on the base unit starts flashing green.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
6
Handset:
When the handset has been registered successfully, you hear a confirmation
tone (long beep) and w stops flashing.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
) with a dry cloth.
, ) or the unit contacts.
S T
, ).
T
) and the charge contacts with a dry cloth and
5