Leds - HP 517 Installation Manual

3 LEDs

Table 1 Startup behavior
Power LED Uplink LED
Off
Amber
Flashing
green
Flashing green in sequence
Green
Alternately flashing
green (quickly)
Alternately flashing
green (slowly)
Table 2 Controlled behavior
LED
Power
Uplink
Radio
LAN
nl
(1 to 4)
PoE
12 LEDs
Radio LED
Off Off The HP 517 has no power.
Power is applied.
If the power LED remains amber for several minutes, the software has failed to
— —
load. If this occurs, reset or power cycle the HP 517. If this condition persists,
contact HP support.
Flashing every two seconds: The HP 517 is starting up.
— — Flashing every second: The HP 517 is looking for an IP address or building the
list of VLANs on which to support discovery.
The HP 517 has obtained an IP address and is attempting to discover a
controller.
Alternately flashing The HP 517 is attempting to establish a management tunnel with a controller.
green
The HP 517 has received a discovery reply form two or more controllers with
Off
the same priority setting.
The HP 517 is attempting to establish an Ethernet connection to the uplink port.
Off
State
Amber The HP 517 has power applied.
Green The HP 517 is associated with a wireless controller and is fully operational.
Off The port is not connected or there is no activity.
Flashing Network activity on a valid 10/100 Mbps link.
amber
Flashing Network activity on a valid 1000 Mbps link.
green
Off Either the radio is disabled or there is no network activity.
Flashing Wireless network activity in 2.4 GHz mode.
amber
Flashing Wireless network activity in 5 GHz mode.
green
Off The port is not connected or there is no activity.
Flashing Network activity on a valid 10/100 Mbps link.
amber
Flashing Network activity on a valid 1000 Mbps link.
green
Off No PoE device is connected.
Amber Class 1 or 2 power is being supplied to the device attached to port 4.
Flashing A fault condition while a Class 1 or 2 PoE device is configured on port 4.
amber
Description
Description