Changing The Side On Which The Door Is Hinged - Siemens WT4HY790GB Installation And Operating Instrictions

Installation and connection
en
Pull out the condensation container
6.
fully.
Turn the condensation container
7.
180° onto its underside and remove
the stopper that is fitted.Turn the
condensation container back over
and insert the stopper into the
recess in the top of the
condensation container.
Pull the filter out of the lock-in slot
8.
and place it into the recess in the top
of the condensation container.
Slide in the condensation container
9.
until it clicks into place.
16
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin
If you want to change the
Note:
condensation drain back to the
condensation container, carry out all
these steps in reverse order.
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
Set the programme selector to the
1.
"Off" position, disconnect the dryer
from the mains and open the door.
Remove the screws from the dryer
2.
and then remove the dryer door.
Use a T20 (Torx) screwdriver
Note:
only. Do not use any other tools to
change the side on which the door is
hinged.