Installing Extension Wand Clips; Filter Removal And Installation - RIDGID 4500RV0 Owner's Manual

SP6951 RIDGID 4.5 Gallon-ESF_SP6609 1/16/15 8:49 AM Page 6

Installing Extension Wand Clips

NOTE: The extension wand clips are
marked "L" and "R" and should be installed
on the back of the PRO PACK unit.
NOTE: While viewing the unit from behind,
the clip marked "L" goes on the left side
and the clip marked "R" goes on the right
side.
Right Extension
Wand Clip
Left
L
Extension
Wand Clip

Filter Removal and Installation

Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small center hole in the top of
the filter over the Qwik Lock™ stud
on the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
Hook the tab on the bottom of the
extension wand clip into the depression
in the bottom of the drum. Rotate the clip
upwards until the extension wand clip
snaps into the slots in the drum, as
shown.
R
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
Integrated Filter
Plate with Center
Hole
PUSH
DOWN
6
Slot
Rotate
Hook
Under Vac
Filter
Cage
Rubber
Gasket at
Bottom of
Filter
PULL
(cutaway
view)