Panasonic KX-TG1810NZ Operating Instructions Manual page 40

Useful Information
Telephone
Problem
I cannot make or receive calls.
The unit does not ring.
The batteries should be charging
but the battery icon does not
change.
A busy tone is heard when {C} is
pressed.
Static is heard, sound cuts in and
out. Interference from other
electrical units.
The handset stops working while
being used.
40
Cause & solution
L The AC adaptor or telephone line cord is not
connected. Check the connections.
L If you are using a BT double adaptor to connect the
unit, remove the adaptor and connect the unit to the
phone wall socket directly. If the unit operates
properly, check or replace the adaptor.
L Disconnect the base unit from the telephone line
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider.
L The call bar feature is turned on. Turn it off (page
22).
L You dialled a call restricted number (page 27).
L The key lock feature is turned on. Turn it off (page
13).
L The ringer volume is turned off. Adjust the handset
ringer volume (page 19) and the base unit ringer
volume (page 25).
L The night mode feature is turned on. Turn it off
(page 20, 25).
L Clean the charge contact and charge again (page
9).
L The AC adaptor is disconnected. Plug in the AC
adaptor.
L The handset is too far from the base unit. Move
closer and try again.
L Another handset is on an outside call. Wait for the
other user to complete the call.
L Locate the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with
ADSL (JetStream) service. We recommend that
you contact your ADSL service provider to have an
ADSL Splitter installed. We do not recommend the
use of generic ADSL filters.
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.