Replacing The Lamp - Zanussi ZBB28442SA User Manual

Problem
The appliance is noisy.
The compressor operates contin-
ually.
Water flows inside the refrigera-
tor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.

Replacing the lamp

CAUTION!
Disconnect the plug from the mains
socket.
www.zanussi.com
Possible cause
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
1. At the same time, with the fingers expand
Check if the appliance stands sta-
ble.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
up and down the transparent cover and
unhook it in the direction of the arrows.
Solution
9