Panasonic NHP8BH1 Operating Instructions & Installation Instructions page 25

Problem
Drying takes too long.
Items made of synthetic
fibres are charged with
static electricity after
drying.
A small item, for example,
a button, has dropped
through the filter frame
hole.
The clogged filter warning
indicator is flashing
although none of the filters
are clogged.
The displayed remaining
time changes.
The operating sound
changes.
'0' display remains after the
programme has finished.
The lamp inside the drum
has gone out.
The lamp inside the drum
does not light up.
Drying has finished with
the Anti-crease set to OFF,
however, the Anti-crease
indicator is flashing.
NH-P8BH1_WGB_En.indb 25
- The laundry may be too wet.
- The laundry may have become tangled.
- The laundry may be too heavy.
- Clothes which dry quickly and clothes which dry slowly
may have been dried together.
- The ambient air temperature may be too low.
- Reduce static electricity charges by adding fabric
conditioners to wash loads during the final rinse cycles.
- Bring the item out by opening the panel in front of the
heat exchanger unit just the same as when cleaning
the fine filter.
- This is not a malfunction; the clogged filter warning
indicator flashes to alert users to clean the filters
th
after every 10 drying programme (twice a month).
The indicator may flash even if the filters have been
cleaned.
- The remaining time is estimated and corrected
continually. Thus, the time displayed may change.
- This is normal; the change is caused by the on-off
conditions of the compressor and draining pump.
- This is not a malfunction; without the Anti-crease
function being set, the appliance automatically switches
itself off 2 hours after the programme finishes.
- The lamp lights up for 10 minutes when the door is
opened after the programme finishes. To activate the
lamp again, switch on the appliance, and then open the
door again.
- If 2 hours have elapsed after a programme is
completed, the lamp will not light up since the appliance
automatically switches itself off.
- For safety, the dryer cools down inside the drum. The
Anti-crease indicator flashes during this time.
Fault Checklist
Cause
Troubleshooting - 25
2014/09/09 15:02:21