Table of Contents
Advertisement
12.4.4 Analog output
Using the analog output, it is possible to choose
whether the measured value is signalled externally
as a registry output, or it is possible to choose the
switching points S1 or S2 as continuous control
outputs. Any range of 0 to 20 mA or 4 to 20 mA
within the measuring range can be assigned to the
analog output. The indicated measuring range is
defined by the start and end values. This also
determines the direction of the analog output.
•
Press the [Right] button to open the "Analog
output" menu.
The following settings are made in the "Analog
output" menu:
•
switching between 0 to 20 mA and 4 to 20 mA
•
analog output start value
•
analog output end value
•
assigning analog output.
Switching between 0 to 20 mA and 4 to 20 mA
Select output
0-20 mA
1. Press the [Right] button to choose between
0-20 mA and 4-20 mA.
2. Press the [Down] button to open the
"Start 0/4 mA" submenu.
Analog output start value
Start 0/4 mA
0.000 mS
1. Press the [Right] button to open the value input
display.
2. Press the [Up] and [Down] buttons to set the
value.
3. Press the [Right] button to save the entry.
4. Press the [Down] button to open the "End 20 mA"
submenu.
Analog output end value
End 20 mA
2.000 mS
1. Press the [Right] button to open the value input
display.
2. Press the [Up] and [Down] buttons to set the
value.
3. Press the [Left] button to save the entry.
4. Press the [Down] button to open the "Analog
output" submenu.
Assigning analog output
1. Press the [Right] button to choose between the
measured value, continuous controller 1 and
continuous controller 2.
Analog output
Measured value
Analog output
Cont. ctrl. S1
Analog output
Cont. ctrl. S2
12.4.5 Language
The "Language" menu is used to determine the
®
language for the Conex
1. Press the [Right] button to open the "Language"
menu.
Sel. language
Deutsch
2. Press the [Right] button to choose between the
languages (German, English, French).
DIS-C.
21
Advertisement
Table of Contents
