Table of Contents
Advertisement
Quick Links
FCC Part 15 B Notice
CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,uses and can radiate radio
frequency energy and,if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.However,there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions :
(1) This device may not cause harmful interference,and
(2) this device must accept any interference received,including interference that may cause undesired
operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:
(1) this device may not cause interference,and (2) this device must accept any interference,including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est
autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage,et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi,même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, CPSIA and FCC.
©2016 Rooftop Brands™ All rights reserved
Tel:+ (1) 949-566-9573 • www.propelrc.com
Cloud Rider
2.4GHz Quadrocopter With Camera
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect Cloud Rider
it is fully charged. Please refer to enclosed safety instructions.
Cloud Rider
TM
Drone
2.4G Wireless Controller
Made in China
INSTRUCTION BOOKLET
battery from charger immediately after
TM
PACKAGE CONTAINS:
Spare Parts
AC Charger
Colors and styles may slightly vary.
TM
Instruction Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Propel Trampolines Cloud Rider
Summary of Contents for Propel Trampolines Cloud Rider
- Page 1 WARNING: Never leave product charging unattended for extended periods of time. Always disconnect Cloud Rider battery from charger immediately after it is fully charged. Please refer to enclosed safety instructions.
-
Page 2: Table Of Contents
Cloud Rider™ Quadrocopter Diagram ........ -
Page 3: Cloud Rider™ Quadrocopter Diagram
• Make sure to be in a large space with an open radius of at least 200 feet. Li-Poly Battery Compartment • Make sure the empty space has no obstacles.Set your Cloud Rider™ on a clean flat surface before take-off. DO NOT ATTEMPT TO FLY YOUR CLOUD RIDER™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING OUTDOORS. -
Page 4: Recognizing The Front & Back Of The Cloud Rider
Below is a list of basic flight functions for your long-range remote control Cloud Rider™.While learning the LEFT TRIM button in the same manner until to fly your Cloud Rider™ it is best to start with a large space until you get used to the basic controls.As the problem is resolved. -
Page 5: Flight Practice
You have the option of attaching the optional camera with precision to your Cloud Rider™ quadrocopter. 1. Install the camera on the under side of the Cloud Rider™ by sliding the camera forward into position and adjust lens angle (see diagram Ra & Rb). -
Page 6: Operating The Camera
1. Once the camera is attached and connected insert the Micro SD card into the camera body (see diagram T). risk of getting into the flight path.Warn spectators that you will be flying your Cloud Rider™ so that they 2. To take still photos press the photo button on the remote (see diagram T1).
Need help?
Do you have a question about the Cloud Rider and is the answer not in the manual?
Questions and answers