Self-Diagnosis And Special Mode Setting; Service Mode Summary Table - Panasonic SA-HT740GCP Service Manual

9 Self-Diagnosis and special mode setting

9.1.

Service Mode Summary Table

The service modes can be activated by pressing various button combination on the player and remote control unit.
Below is the summary of major checking:
Player buttons Remote control unit buttons
STOP
9.2. Service Mode Table
By pressing various button combinations on the player and remote control unit can activate the various service modes for checking.
Special Note:
Due to the limitations of the no. characters that can be shown on FL Display, the "FL Display" button on the remote control unit
is used to show the following page. (Display 1 / Display 2).
0 Error code display
5 Jitter checking
6 Region disply and mode.
7 Micro-processor firmware version check.
8 DVD HDMI module firmware version check.
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer, FLASH ROM IC,
EEPROM and HDMI module.
ENTER DVD module reset (During initialisation)
FUNCTIONS DVD laser drive current check
3 CD laser drive current check
PAUSE Writing of laser drive current value after replacement of optical
pickup (Do use this function only when optical pickup is
replaced.)
Application
19
SA-HT740GCP
Note
(Refer to the section,
"9.3 DVD Self Diagnostic
Function-Error Code").
(Refer to the section
"9.2.1. Service Mode
Table 1" for more
information).
(Refer to the section
"9.2.2. Service Mode
Table 2" for more
information).
(Refer to the section
"9.2.4 Optical Pick-up
Self-Diagnosis").