Maintenance; Fcc Disclaimer - HoMedics Deep Sleep Instruction Manual And Warranty Information

Using the Auto-Timer
1. When the power is on and you are listening to a white noise tone, you may set a timer so the
unit will automatically turn off.
2. Toggle through the TIMER button (Fig. 2) until the corresponding LED illuminates next to
the time of your choice, 30, 60 or 90 minutes. The unit will automatically shut off after the
selected time and the POWER LED (Fig. 2) will remain lit showing you it is still in timer mode.
If you chose to listen to another timed sound, press the timer button to select a desired time.
Or if you choose to listen to the sounds continuously, turn the unit off and then back on.
NOTE: Do not select the TIMER button if you wish to listen to the sounds continuously.

Maintenance

To Store
You may leave the unit on display, or you can store it in its box in a cool, dry place.
To Clean
Wipe off dust with a damp cloth. NEVER use liquids or abrasive cleaner to clean.
Modifications not authorized by the manufacturer may void users authority to operate
this device.

FCC Disclaimer

NOTE: This device complies with Part 15 of the FCC guidelines. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user in encouraged to try to correct the
interference by one or more of the following measure:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
5