Assembly And Adjustments - Hitachi P 13F Instruction Manual And Safety Instructions

ASSEMBLY AND ADJUSTMENTS

Never connect the plug to the power source outlet until all installations and adjustments are completed and
you have read and understood the safety and operational instructions.
ESTIMATED ASSEMSLY TIME 20~35 MINUTES
ASSEMBLY INSTRUCTIONS
Lift the tool from the packaging and place it on your
workbench. Carefully open the front and rear extension
tables and take out the loose parts bag and power cord.
ASSEMBLE STAND (FIG. A)
1. Unpack all parts and sort by type and size.
Refer to the parts list on page 21 for correct
quantities.
2. Attach long upper crossbar (4) to top of leg (1) and
adjacent leg using carriage bolts (2) and nuts (5).
NOTE: Do not tighten bolts until step 7.
3. Attach long lower crossbar (3) to bottom of leg (1)
and adjacent leg using carriage bolts and nuts.
4. Repeat on opposite side of stand.
Fig. A
2
WARNING
5. Join the front and back of stand, using short upper
6. Place foot pads (7) on legs.
7. Place the stand on a level surface and make sure all
ASSEMBLE PLANER TO STAND
1. Carefully place planer on top of stand.
2. Line up the four mounting holes on tool base with
3. Fasten the planer to the stand using mounting bolts
4. Tighten all nuts.
12
13
14
6
11
5
10
7
– 11 –
(11) and lower (10) crossbars, carriage bolts and
nuts.
legs are contacting the floor and are at similar angles
to the floor. Tighten all bolts.
those on the stand.
(12), washers (13) and nuts (14) (see Fig. A).
NOTE: DO NOT OVER TIGHTEN NUTS.
4
3
1
English