Other Functions; Using An External Unit; Using Headphones (Not Included); Turning The Demo Function On/Off - Panasonic SC-AK220 Operating Instructions Manual

Other functions

AUX

Using an external unit

(See page 4 for external unit connection.)
1. Press [AUX].
The unit comes on.
2. For listening: Proceed to step 3.
For recording: Press [a, REC] (recording starts).
3. Start playback from the external source. (For details, refer to the
external unit's instruction manual.)

Using headphones (not included)

Reduce the volume level and connect the headphones.
1
Plug type: 3.5 mm ( / ˝) stereo
8
Note
Avoid listening for prolonged periods of time to prevent hearing damage.

Turning the demo function on/off

When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [DISP, –DEMO].
The display changes each time the button is held down.
NO DEMO (off) DEMO ON (on)
While in the standby mode, select "NO DEMO" to reduce power
consumption.
Note
DEMO function cannot be turned on when Dimmer is on.
12
RQT7528

Auto-off function

Remote control only
When CD or tape is selected as the source
To save power, the unit turns off if it is left unused for ten minutes.
This function does not work if the source is tuner or AUX.
Press [SHIFT] + [AUTO OFF].
"AUTO OFF" is shown on the display.
The setting is maintained even if the unit is turned off.
If you select tuner or AUX as the source, "AUTO OFF" goes out. It
comes on again when you select CD or tape.
PHONES
To cancel
Press [SHIFT] + [AUTO OFF] again.
VOLUME

Setting the time

Remote control only
This is a 12-hour clock.
1
Switch on the power.
2
Press [SHIFT] + [CLOCK/TIMER] to select "CLOCK".
Every time you press the button:
CLOCK
3
(Within 7 seconds or so)
Press [g, REW/3] or [f, 4/FF] to set the time.
4
Press [SHIFT] + [CLOCK/TIMER] to finish setting the
time.
The display will return to whatever was displayed before you set
the time.
To display the time
Press [SHIFT] + [CLOCK/TIMER] once when the unit is on or at
standby mode.
The time is shown for about 5 seconds.
Note
Reset the clock regularly to maintain accuracy.

Convenient functions

To dim the display panel
Remote control only
Press [DIMMER].
The display is dimmed and the indicators are turned off.
(The AC supply indicator remains on.)
Press [DIMMER] again to restore the display.
To mute the volume
Remote control only
Press [MUTING].
Press the button again to cancel.
"MUTING" goes out.
To cancel from the unit, turn [VOLUME] to minimum (--dB), then raise
it to the required level.
Muting is also cancelled when the unit is turned off.
PLAY REC
Previous display