Remote Control Unit Preparation; Troubleshooting - Panasonic CQ-DP153W Operating Instructions Manual

Remote Control Unit Preparation

E
N
G
L
I
S
Battery Installation
H
q Remove the battery holder.
13
Pull the battery holder by the position B while pushing
position A in the direction indicated by the arrow.
w Install the battery on the battery holder.
Place a battery in the holder with its "+" side facing up as
shown in the figure.
e Insert the battery holder.
Push the battery holder back into its original position.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
• Battery type: Panasonic lithium battery (CR2025) (included)
• Battery life: Approximately 6 months with normal use (at room temperature)
Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
• Do not disassemble or short the battery. Do not throw a battery into a fire.
• Keep batteries away from children to avoid the risk of accidents.
• Be careful to observe proper local disposal rules when you dispose of batteries.
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit's sensor.
[PWR]
PWR
(Power)
[MODE]
MODE
(Mode (source))
( page 8, 10)
PRG
[BAND]
BAND/DISC UP
(Band)
( page 8)
TRACK
Car Audio
18
CQ-DP153W
Lithium battery
(included)
Back side
Battery holder
Position A
APM
(ATT) POWER
[MUTE]
MUTE
(Mute)
( page 6)
VOL [VOL] [j] [i]
(Volume )
TUNE
[TUNE] [TRACK] [k] [l] [s] [d]
(Tune/track selection/track search)
( page 8, 11)

Troubleshooting

Preliminary Steps
Check and take steps as described in the tables below.
If You Suspect Something Wrong
Immediately switch the power off.
w
Disconnect the power connector and check that there is neither
Position B smoke nor heat from the unit before asking for repairs. Never try to
repair the unit by yourself because it is dangerous to do so.
e
Troubleshooting Tips
q
Common
Trouble
No power.
7
MUTE 1 No sound.
Noise.
Caution:
• Do not use the unit if it malfunctions or if
there is something wrong.
• Do not use the unit in irregular condition,
for example, without sound, or with smoke
or foul smell, which can cause ignition or
electric shock. Immediately stop using it
and call the store where you purchased it.
Cause/Step
Car's ignnition switch is not on.
Turn your car's ignition switch to ACC or ON.
Cables are not correctly connected.
Connect cables correctly.
Battery cable is not correctly connected.
Connect the battery cable to the terminal that is always active.
Accessory cable is not correctly connected.
Connect the accessory cable to your car's ACC source.
Grounding wire is not correctly connected.
Connect the grounding wire to a metal part of the car.
Fuse is burnt out.
Call the store where you purchased the unit.
Mute is set to ON.
Set it to OFF.
Cables are not correctly connected.
Connect cables correctly.
Condensation (dew).
Wait for a while before use.
Grounding wire is not correctly connected.
Connect the grounding wire to a metal part of the car.
CQ-DP153W
E
N
G
L
I
S
H
14
19