7.14. Remove the SS2-Board
1. Disconnect the connector (SS24) and disconnect the flex-
ible cable (SS58A).
2. Remove the screws (×2
7.15. Remove the Stand brackets
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered)
with the Plasma panel surface facing downward.
2. Remove the Stand brackets (L, R) fastening screws
(×5
each) and remove the Stand brackets (L, R).
) and remove the SS2-Board.
7.16. Remove the D-Board
1. Remove the A-Board unit. (See section 7.7.)
2. Disconnect the connectors (D3, D5 and D25).
3. Disconnect the flexible cables (D20, D31, D32 and D33).
4. Remove the screws (×4
7.17. Remove the C1-Board
1. Remove the A-Board unit. (See section 7.7.)
2. Remove the Speaker box (Woofer/R). (See section 7.9.)
3. Remove the Stand bracket R. (See section 7.15.)
4. Remove the DD-Heat-sink fastening screws (×12
5. Remove the DD-Heat-sink (×6).
6. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5 and CB6).
7. Disconnect the flexible cables (C10 and C11).
8. Remove the screws (×5
22
) and remove the D-Board.
).
) and remove the C1-Board.