Advertisement
RJ45 Connector for Audio/Video
To build your own A/V RJ45 connectors, please follow the PIN-
OUTS shown below.
NOTE: TPT650 Wiring
•
CAT5e network cable with RJ45 connectors.
•
Romex or equivalent 120-220VAC power supply*
•
Each TPT650 may also have up to four A/V cables using
CAT5e with RJ45 connectors and an A/V Connector
Cable – part number VDA-0176 shown above – on the
A/V end.
*See the TPT650-INSTALL-16 sheet
3
9
6
3
1
/
n I
F
u
s
o i
n
c
o
m
p
t a
b i
e l
VDA-0176 A/V Connector Cable
The TPT650-INSTALL-16 kit ships with one VDA-0176 A/V
connector cable. Additional cables may be purchased from
Vantage Controls. This cable connector is designed to connect
directly to the A/V equipment using the RCA connectors. Use a
straight through RJ45 (female) coupler allowing the installer to
run longer CAT5e wire runs with male, RJ45 type connectors to
the TPT650 and the VDA-0176 connector cable. A/V wire runs
should not exceed 200ft. Please see the TPT650-INSTALL-16
install sheet for details.
SD Memory Card
For most applications the built-in memory will be sufficient.
However, the TPT650 allows an SD Memory card to be inserted
if it is anticipated that the design will require more than the
default memory.
NOTE: To avoid possible configuration issues, power down the
TPT650 when inserting or removing the SD Memory Card.
Reprogram the TPT650 after inserting an SD Memory card.
Connection Status Indicator
In the Configuration screens mentioned earlier, notice the round
highlighted indicator in the upper right hand corner. This indicator
changes appearance to indicate the connection status of the
TPT650. Use this indicator to help trouble shoot issues if the
screen appears to have connection issues. The indicator
changes colors as indicated below.
Indicator Color
Green
Connected and properly configured
Connected to controller but not properly
Yellow
configured on the controller
Grey
Not connected to a controller
Red
Ethernet disconnected
Connection Status
©
V
a
n
a t
g
e
Advertisement
