Configure your router
Advanced
Virtual server:
Click Virtual Server in the left pane. This page allows you to configure the
•
virtual server so that others can access the server through the Gateway.
•
Usual Service Name & User-defined Service Name: The name of this
virtual server.
•
Protocol: The protocol of this virtual server used. It can be TCP or UDP.
•
WAN Setting: The WAN setting of this virtual server used. It can be
Interface or IP address.
•
WAN Interface: The interface on which the virtual server used on WAN
side.
•
WAN Port: The open port on WAN side. It can be either a single port or a
port range.
•
LAN Open Port: Enter the specific start and end port number you want
to forward. If it is one port only, you can enter the end port number the
same as start port number. For example, if you want to set the FTP virtual
server, set the start and end port number to 21.
•
LAN IP Address: The IP address of the host which provides the service
on LAN side.
The Current Virtual Server Forwarding Table displays the information
•
about the virtual servers you established.
22