Rebreather Diving; Sample Rate - Suunto DX User Manual

Hide thumbs Also See for DX:

Table of Contents

3.17 Rebreather diving

Suunto DX has one mode dedicated to rebreather diving, CCR

mode. This mode uses fixed high/low setpoint values which you can

modify in the watch or through DM5.

Fixed setpoint calculation enables Suunto DX to be used as a

backup dive computer on rebreather dives. It does not control or

monitor the rebreather unit in any way.

3.11.3 CCR mode ), the gas settings

When you select CCR mode (see

split into two: CC gases (closed-circuit gases) and OC gases (open-

circuit gases).

NOTE: For rebreather dives, Suunto DX should be used as a

backup device only. The primary control and monitoring of your

gases should be done through the rebreather itself.

The sample rate controls how often information from the dive is

saved to the active log. The sample rate options are: 10, 20, 30 and

60 seconds. The default sample rate is 20 seconds.

To change the sample rate:

1. While in a dive mode, keep [DOWN] pressed.

2. Press [UP] to scroll to Sample Rate and press [SELECT].

3. Press [DOWN] or [UP] to change the rate and confirm with

[SELECT].

4. Press MODE to exit.

Table of Contents