Panasonic CQ-5250U Operating Instructions Manual page 19

❐ Preparation
Warning
If your vehicle is equipped with air bag and/or anti-theft sys-
tems, specific procedures may be required for connection and
disconnection of the battery to install this product.
Before attempting installation of this electronic component,
contact your vehicle dealer or manufacturer to determine the
required procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE
UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION
OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO
THE VEHICLE AND PERSONAL INJURY.
• Disconnect the cable from the negative
warning and caution below).
• Remove Mounting Collar q from the main unit temporarily,
which are already mounted at shipment.*
Caution
Various settings that have been stored in the memory in other
on-board equipment (vehicle navigation etc.) may be lost if the
battery terminals are disconnected.
Therefore, we recommend to make a record of or to back up
the settings before disconnecting the terminals.
After completing installation of the main unit, set the equip-
ment again according to the record.
• Unit should be installed in a horizontal position with the front
end up at a convenient angle, but not more than 30˚.
0 - 30°
❐ Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an opening as
shown below. The dashboard should be 4.75 mm {3/16"} - 5.56
mm {7/32"} thick in order to be able to support the unit.
(-)
battery terminal (see
❐ Installation Hardware
No. Item
q
Mounting Collar*
w
Plain washer (5 mmø)
e
Spring Washer (5 mmø)
r
Hex. Nut (5 mmø)
t
Rear Support Strap
Hex. Bolt
y
(5 mmø × 25 mm)
Toothed Lock Washer
u
(5 mmø)
Removal Tool
i
(U-shaped)
CQ-5250U
Diagram Q'ty
1
2
2
2
1
1
1
2
19