CQ-5330U PUSH SEL / SAT DISP MODE DISC CD SCAN BAND BASS/TREB/BAL/FADER • Please read these instructions carefully before using this product and keep this manual for future reference. Heavy Duty CD player/weather Band Receiver with CD changer Control/XM Radio Ready...
Find the model number and serial number on either the back or bottom of the unit. Please record them in the space below and retain this booklet as a permanent record of your purchase to help with identification in case of theft. MODEL NUMBER CQ-5330U DATE PURCHASED CQ-5330U The following applies only in the U.S.A.
Panasonic welcomes you to our ever growing family of electronic product owners. We know that this product will bring you many hours of enjoyment. Our reputation is built on precise electronic and mechanical engineering, manufactured with carefully selected components and assembled by people who take pride in their work.
Adjustable range: 1 to 15 (by 1 step) Fader: F (front speaker) or R (rear speaker) Adjustable range: 1 to 15 (by 1 step) CQ-5330U Note: If no operation takes place for more than 5 Treble push CQ-5330U DISC CD SCAN...
Note: Press and hold [{ ] or [} ] to change numbers rapidly. The 12-hour system is used for the clock. Initial Time “SET” is displayed when the clock is not adjusted. CQ-5330U LOUD MUTE CD SCAN SCAN [{ TUNE], [} TUNE]...
Note: Press and hold [{] or [}] to change numbers rapidly. Alarm Time Reset When you want to reset the alarm time, repeat steps q to r. CQ-5330U CQ-5330U DISC CD SCAN Alarm Operation • Alarm is switched to ON or OFF each time [ALM] is pressed.
Press and hold for more than 0.5 seconds and release it. [}TUNE]: Higher frequency [{TUNE]: Lower frequency Tuning will automatically stop when the next broadcast station is received. CD Player CD Changer Control ( When a CD changer is connected ) CQ-5330U DISC CD SCAN LOUD MUTE TUNE TUNE SEEK...
Page 10
Press and hold one of the preset buttons from [1] to [6] until the display blinks once. Preset Station Calling Press the corresponding preset button from [1] to [6] to tune in a preset station. CQ-5330U CQ-5330U DISC CD SCAN Preset buttons from [1] to [6] (➡...
Page 11
CQ-5330U SEL / SAT PUSH DISP MODE DISC BAND BASS/TREB/BAL/FADER Tuning in a Weather Band Station • Press [BAND] to select WB (Weather Band). • Press any of the buttons [1] to [6] to monitor the preset station. Note: The weather band (CH1-6) has been preset. CH7 is selected by pressing [}] or [{].
Press [u] (eject) to stop CD play and eject the disc. During disc ejection, “CD EJECT” will be displayed. Listening to a CD Press [MODE] to change to the CD player mode. Playback will start automatically when a disc is loaded. Radio...
• If you insert an 3" (8 cm) disc and can not eject it, turn ACC of your car off once and turn it on again, then press [u] (eject). • Do not use irregular shaped discs. • Do not use discs that have a seal or label attached. • Do not insert foreign matter into the disc slot. CQ-5330U PUSH SEL / SAT DISP MODE...
Track Search Press and hold [TRACK 2] or [TRACK 1] for more than 0.5 seconds to activate fast forward or reverse through a track. Release it to resume the normal CD play from that position. CQ-5330U CQ-5330U DISP MODE MODE...
• Press and hold [6] (RDM) for more than 2 seconds again to cancel ❐ Remote Control CA-RC500U (option) blinks blinks lights REP: Repeat lndicator blinks REP: Repeat lndicator lights R : Random Indicator blinks R : Random Indicator CQ-5330U...
XM Control Preparation: Connect the XM receiver (XM DIRECT MODEL:XM-RVR-D-001) to the Unit CQ-5330U. XM satellite radio is available on a chargable basis. q XM Mode (When a XM receiver is connected.) Press [MODE] to change to the XM mode.
Page 17
Note: When category is on category will be off after pressed any preset button [1] to [6]. Category Name Category Name (without operation during 5 seconds.) Press [2] or [1]. (Receiving) (Received) (interdisplay for 2 seconds.) category on indicator CQ-5330U...
Page 18
• Push the knob for more than 2 seconds to resume to the previous mode when displaying “RADIO ID” or ID number. • You can also see ID number by selecting CH0. Error display XM ID is or communication fails, Press [MODE] to another mode. CQ-5330U (Push) Channel name (Reading artist name)
Connect the grounding wire to a metal part of the venicle. Mute is set to ON. Set it to OFF. Cables are not correctly connected. Connect cables correctly. The ground lead is not connected properly. Connect the ground lead properly. CQ-5330U...
Page 20
Sound skips, bad sound quality. (e.g. caused by noise) CQ-5330U (Continued) Cause/Step Station is too far, or signals are too weak. Select other stations of higher signal level. The radio antenna is not extended enough.
Page 21
No chanel service select a channel which can be received. The original channel cannot receive signal. select a channel which can be received. Do not connect the XM receiver completely. Check the XM receiver's connections. CQ-5330U...
Eject the magazine. If failure persists, press the reset switch on the CD changer. If normal operation is not restored yet, call the store where you purchased the unit to the nearest panasonic servic center to ask for repairs. No disc in the changer (magazine) ➡...
Care of the Unit ❐ Caution on Cleaning Never use solvents such as benzine, thinner as they may mar the surface of the unit. Notes on Discs Label side Do not use irregular shaped discs. <Right> Notes on CD-Rs/RWs <Wrong> CQ-5330U...
Product Servicing If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized Panasonic Servicenter. The product should be serviced only by a qualified technician. Maintenance Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for routine exterior cleaning.
Before you begin installation, look for the items which are packed with your unit. • Warranty Card…Fill this out promptly. • Panasonic Servicenter List for Service Directory WARNING …Keep for future reference in case the product needs servicing.
Page 26
This unit can be installed in any dashboard having an opening as shown below. The dashboard should be 3/16” (4.75 mm) – 7/32” (5.56 mm) thick in order to be able to support the unit. CQ-5330U ❐ Installation Hardware Item Mounting Collar* Plain washer (5mmø)
Page 27
Establish the rear connection of the unit. After fixing Power Connector, fix the rear of the unit to the vehicle body by either method (a) or (b) shown in the previous page. After installation reconnect the negative (–) battery terminal. Mounting Hole CQ-5330U...
Page 28
Installation (Continued) To Remove the Unit from the vehicle's dashboard Insert each Removal Tool i and pull. i Removal Tool (U-shaped) Note: Do not lose Removal Tools. They will be needed to remove the unit from the vehicle's dashboard. CQ-5330U...
If need, please consult your dealer. (Gray/Black) (white) (White/Black) Left Speaker (Front) 10 12 14 16 CD Receiver 11 13 15 CQ-5330U (Rear Side) Detail of power connector FUNCTION Power Connector BATTERY +12 V GROUND POWER +12 V ACC Ground Battery...
Page 30
❐ Upgrading the system (connect a XM receiver and the wired remote.) Note: For wiring, carefully read the operation instructions for the devices connected. Wired Remote Connector (8P connector) antenna XM ANT (XM-RVR-D-001) CQ-5330U (Continued) CQ-5330U APM/PRG DISP SEEK MODE BAND...
Page 31
❐ Upgrading the system (connect a CD changer and the wired remote.) Note: For wiring, carefully read the operation instructions for the devices connected. Wired Remote Connector (8P connector) CD Changer (CD-DP880, option) CQ-5330U APM/PRG DISP SEEK BAND MODE TUNE...
Page 35
Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 YFM284C420ZA TAMACO0204-0 Printed in Taiwan...